Decimus has one of the ADC inputs dedicated to monitoring the battery voltage. The batteries used in this micromouse are Lithium Polymer cells and it is particularly important that they are not allowed to discharge too far. Since the full battery voltage is about 7.4 Volts, this gets divided by four in a simple resistive divider before being sampled by the ADC.
Having installed the LCD, it was time to get the code working for it. First I realised that it may not have been so clever to put the LCD on the same SPI port as the encoders. This will mean that I have to take care that the encoders are not being read when the LCD is active. Since the encoders are sampled every interrupt, it means turning them off while writing to the screen. That, in turn, means not writing to the screen while moving, or holding position. I may end up having to patch the board to put the LCD on the other SPI port. In fact, I wish I had done that in the first place as it would just share lines with the UART and I could easily switch between the UART and the SPI for writing debugging messages. Ah well, live and learn. (more…)